Profile

  

- Conducted engineering site survey.
- Install Metro
- E equipment at site once the survey report has been approved.
- Performed testing & commissioning after the installation completed by using using PON power meter.
- Prepare acceptance testing report for customer before hand over.

- Conducted engineering site survey before equipment deployment.
- Install equipment MA 5600T at site once the survey report has been approved.
- Performed testing & commissioning after installation by using test gear PON power meter and variable attenuator.
- prepare acceptance test report for customer before hand over.

- Performed testing & commissioning by using VDSL modem to make sure there are three services available such as voice, internet. and IPTV.
- Prepared acceptance test report for customer before hand over take place.

- Installed the 2.4Ghz antenna for point to point communication.
- We were doing alignment to make the antenna able to communicate with each other.
- Besides, we also installed access controller, switch and modem to complete the installation

- Conducted engineering site survey
- Install the equipment after all technical site survey has been approved
- Perform testing and commissioning after the installation complete
- Prepare the acceptance test document and hand over to customer

  

- Conducted engineering site survey.
- Deployed equipment Cx 600 router after the survey report approved.
- Cx 600 router is connected to OLT (optical line terminal)

- Conducted engineering site survey.
- install equipment MA 56O0T at site after survey report approved.
- Performed testing & commissioning by using PON power meter and variable attenuator to make sure there are three services available such as voice, internet. and IPTV.
- prepare user acceptance test report for client before hand over.

- Conducted engineering site survey.
- After survey report approved then proceed with equipment installation at site
- Performed testing & commissioning by using test gear Ethersam to test for packet trans mission and to make sure there is no packet loss.
- Prepare acceptance test report to client before handover.
- Migrate the existing node B to MxU (MA 5612) in order to upgrade it to the higher bandwidth.

- Lay 1 pair of fiber optic cable from distribution point to customer house.
- Once the ï¬Âber optic cable is lay. performed splicing for both end ï¬Âber optic cable to bridge the connection.
- Performed test to verify the services are up such as voice, internet and IPTV.
- For maintenance, our team performed troubleshooting in order to identify thecause of the services break down.

We installed the cabling system for this project such as G.I. conduit, power cable, VMS DB, catweld earthing and others.
- We have installed the VMS DB in order for DBKL to control the digital signage display remotely.